Brightwell Brightstar II Mode D'emploi page 42

P T
ULSE EST
In order to check that all of the required inputs are receiving
signals (and to test for inputs which are receiving multiple
signals), the BrightStar software provides a PULSE TEST
screen.
To Access:
From the default screen, press the
The screen will display a numerical counter for each of the
inputs, which will show the number of signals which have been
accepted on each input (i.e. Signals, which exceed the signal
acceptance time), up to the selected pulse count.
i.e. If the pulse count is set to 01, the first signal will be
displayed, all others will be ignored until the unit has reset. If the
pulse count is set to "ALL", every signal will be counted.
All of the counters will reset when the unit does (see page 32).
The screen will also show the unit receiving signals in "real
time", via the 10 cursors (or 6 on a 1-6 pump unit) along the
bottom of the screen, which will illuminate when any signal is
present.
This saves the engineer from having to use a voltmeter to
check each input.
To return to the default screen, press the
S
OFTWARE
In order to view the unique serial number of the unit, along with
the BrightStar software version number:
From the default screen, press either the
The display will change to show the: -
S/W VERS: (software version number)
S/N: (units unique serial number)
The unit will return to the default screen after 5 seconds.
B L S
RIGHTSTAR AUNDRY YSTEMS
TEST
key.
TEST
/S N
ERIAL
UP
or
00000
IP1=00 2=00 3=00
00000
key again.
UMBER
00000
DOWN
key.
00000
S/W VERS:
S/N:
00000
41
BSL10 01
BRIGHTWELL
4=00 5=00 6=00
7=00 8=00 9=00
10=00----------
BSL10 01
BRIGHTWELL
BSL10 01
BRIGHTWELL
BSL10 01
2.71
070496489
BSL10 01
BRIGHTWELL
E
NGLISH
IP1=00 2=00 3=00
4=00 5=00 6=00
------
B L S
RIGHTSTAR AUNDRY YSTEMS