Brightwell Brightstar II Mode D'emploi page 31

P
ROGRAMMING
By default, all of the pumps will initially be set to "DISABLE" on
all of the inputs.
Use the FWD/ACCEPT
that you wish to run when a signal is received on the selected
input.
UP DOWN
Use the and
selected pump from "DISABLE" to "ENABLE".
FWD/ACCEPT
Use the
to the PUMP DELAY TIME screen for the pump you have just
enabled.
P
ROGRAMMING
The BrightStar software, allows the user to program a time
delay between the unit receiving a signal from the host
machine, and the appropriate pump running.
This would be used to reduce the chance of neat products
(such as Hypochlorite bleach) being introduced over dry
clothing, as this may cause the clothes to be damaged.
Setting:
UP DOWN
Use the and
FWD/ACCEPT
Use the
on to the RUN TIME/DOSAGE screen.
Note:
If a flow rate has been set for the selected pump, the next
screen will be the DOSAGE screen (see page 31).
If no flowrate has been set, the next screen will be the RUN
TIME screen (see page 31).
B L S
RIGHTSTAR AUNDRY YSTEMS
-
E
NABLING
BACK
and keys to select the pump
keys to change the condition of the
key to confirm your selection and move
-
P
UMP
keys to alter the delay time selection.
key to confirm your selection and move
P
UMPS
SET DELAY TIME
D T
ELAY IME
SET DELAY TIME
SET DELAY TIME
see "Run Time"
30
PROGRAM 01
SET INPUT 02
SET PUMP 01
DISABLE
PROGRAM 01
SET INPUT 02
SET PUMP 04
DISABLE
PROGRAM 01
SET INPUT 02
SET PUMP 04
ENABLE
INPUT2/PUMP4
00MINS 00SEC
INPUT2/PUMP4
00MINS 00SEC
INPUT2/PUMP4
00MINS 15SEC
INPUT2/PUMP4
SET RUN TIME
00MINS 00SEC
section
(page 31)
E
NGLISH
INPUT2/PUMP4
DOSAGE
00000ml
see "Dosage"
section
(page 31)
B L S
RIGHTSTAR AUNDRY YSTEMS