Brightwell Brightstar II Mode D'emploi page 29

P
ROGRAMMING
From the PUMP SPEED/FLOWRATE screen, press the
FWD/ACCEPT
key to move to the INPUT SELECTION screen.
From this screen the user can select which inputs they wish to
assign to which pump.
BrightStar units have a maximum of:
6 inputs for 1-6 pump units.
10 inputs for 7-10 pump units
The inputs are situated on the A & B rails of the powerboard.
Each input can be assigned to an individual pump, multiple
pumps or all pumps.
Example:
If the unit has been installed with signals from the host machine
to inputs 01-04 on the powerboard, you will need to assign
pumps to inputs 01-04.
Setting:
UP DOWN
Using the and
signal wired to it.
FWD/ACCEPT
Press the
screen for the selected input.
Example:
In this example we want to program the unit to run pump 4 for
30seconds, when a signal is received on input 2.
Alternatively:
If needed, the INPUT SELECTION screen can also be used to
access the pump settings for additional programs (formulas).
BrightStar units can have a maximum of 20 programs (see
page 34).
PROGRAM
Use the key to increment the program number at
the top of the screen. The settings of this program can then be
specified.
B L S
RIGHTSTAR AUNDRY YSTEMS
-
S
ELECTING
keys, select the first input which has a
key to move to the PULSE COUNT
I
NPUT
PROGRAM 01
SET INPUT 01
PROGRAM 01
SET INPUT 02
PROGRAM 01
SET INPUT 02
PULSE COUNT
001
28
E
NGLISH
PROGRAM 02
SET INPUT 01
see page 34
B L S
RIGHTSTAR AUNDRY YSTEMS