Brightwell Brightstar II Mode D'emploi page 27

P
ROGRAMMING
The Flush Valve Time, is the time for which the flush valve
will open, after the assigned pump is run.
Set the flush valve time (00 - 99 Mins) using the
keys.
FWD/ACCEPT
Press
the PUMP SPEED screen.
Note:
Once set, this time will apply to ALL Flush Valves.
P
ROGRAMMING
From the FLUSH VALVE TIME screen (or the ASSIGNING
MANIFOLD screen if flush valves are not needed), press the
F W D / A C C E P T
SPEED/FLOWRATE screen.
The BrightStar software allows the user to program each pump
with a Flowrate (see page 27) and/or a Pump Speed.
PUMP SPEED:
(not available on BSHL units)
The user can set the speed of each individual pump (20% -
100% of full speed, in 5% increments).
This can be used to reduce the strain on the pumps when they
are used with thick product.
Setting:
UP DOWN
Use the and
selected pump.
FWD/ACCEPT
Press
on to the next pump.
Once all of the pump speeds/flowrates have been set, press
SEE/JUMP
the key to move onto the PROGRAM SETTINGS
screen.
B L S
RIGHTSTAR AUNDRY YSTEMS
-
F
LUSH
to select the displayed time and move to
-
P
UMP
k e y t o m o v e t o t h e P U M P
keys to select the desired speed for the
key to confirm your selection and move
V T
ALVE IME
UP DOWN
and
R S (
UN PEED DC UNITS ONLY
26
FLUSH VALVE
TIME
00MINS 00SECS
)
SET PUMP 1
SPEED
080%
SET PUMP 2
SPEED
080%
SET PUMP 3
SPEED
080%
SET PUMP 10
SPEED
080%
PROGRAM 01
SET INPUT 01
E
NGLISH
FLUSH VALVE
TIME
00MINS 20SECS
SET PUMP 1
SPEED
080%
B L S
RIGHTSTAR AUNDRY YSTEMS