Brightwell Brightstar II Mode D'emploi page 38

P
ROGRAMMING
The BrightStar unit will default to its "Standard" operational
mode.
However if the host machine is "Intelligent" (ie. computer
controlled), it may be preferable to use the RELAY mode
(Descriptions of both of the unit's operational modes can be
found on page 3)
To access the RELAY mode:
From the default screen (see opposite) hold down the
SEE/JUMP
key, then press the
Enter the correct four-digit access code using the
DOWN
keys to select a number and the
move on (as shown on page 24).
UP DOWN
Use the and
operational modes.
Once the required operational mode is displayed, press the
FWD/ACCEPT
key to confirm your selection.
The selected mode will be displayed on screen briefly, while the
unit changes mode.
The unit will then revert to the default screen for the selected
mode (see opposite).
B L S
RIGHTSTAR AUNDRY YSTEMS
-
A
CCESSING
keys for 2 seconds.
FWD/ACCEPT
keys to toggle between the two
R M
ELAY ODE
00000 BSL10
BRIGHTWELL
ENTER CODE TO
CHANGE UNIT MODE
----
TEST
ENTER CODE TO
CHANGE UNIT MODE
UP
and
1---
key to
ENTER CODE TO
CHANGE UNIT MODE
1111
SELECT
UNIT MODE
STANDARD MODE
STANDARD MODE
00000 BSL10
BRIGHTWELL
see page 24
37
E
01
(2 seconds)
SELECT
UNIT MODE
RELAY MODE
RELAY MODE
01
RELAY MODE
BRIGHTWELL
see page 38
B L
RIGHTSTAR
NGLISH
BSL10
S
AUNDRY YSTEMS