Brightwell Brightstar II Mode D'emploi page 21

C
HEMICAL
Once a Chemical Enable module is fitted, it will be automatically acknowledged by the unit, and the relevant pumps
(see table below) will be disabled.
Pressing the corresponding button on the module can then individually activate the pumps. A light will illuminate to
indicate that the chemical will be included in the wash cycle.
In case of accidental selection, the chemical can be de-selected by pressing the button again.
UNIT
BSL2
BSL4
BSL6
C
HEMICAL
Important Safety Instructions
Please read the following precautions carefully before using this equipment.
Do not
attempt to fit the module
Do not
use damaged or frayed cables.
Do not
dismantle or modify this equipment.
C
HEMICAL
E -
NABLE
O
Button A Button B
Pump 2 No effect
Pump 2 Pump 4
Pump 4 Pump 6
E -
NABLE
S
without first isolating the signal and supply sources from the host unit.
E -
NABLE
L
Button A
Indicator
Button A
PERATION
UNIT
BSHL2
BSHL4
BSHL6
P
AFETY RECAUTIONS
AYOUT
A B
20
Button A Button B
Pump 2 No effect
Pump 2 Pump 4
Pump 4 Pump 6
Button B
Indicator
Button B
B
RIGHTSTAR
E
NGLISH
L S
AUNDRY YSTEMS