Publicité
Les langues disponibles
Les langues disponibles
P
ROGRAMMING
From the default screen, press the
Enter the correct four-digit access code using the
DOWN
keys to select a number and the
move on/confirm.
The unit will then give the option of editing the:
Settings
(see below)
Or
Cycle Counters
(see page 36)
UP
DOWN
Press
and
FWD/ACCEPT
to accept your choice and move on the next
screen.
Note:
While in PROGRAMMING MODE the unit will not run and will
not accept input signals from the host machine.
P
ROGRAMMING
From the SETTINGS screen, press the
move to the SIGNALACCEPTANCE screen.
Usually set to 1 second, the signal acceptance time is the time
that a signal has to remain across an input, before it is
acknowledged. Once set, this time will apply to all inputs and all
programs.
Setting:
Set the Signal Acceptance Time (00 - 99 Secs) using the
DOWN
and
keys. Press
and move on to the ASSIGNING MANIFOLD screen.
Note:
This screen will be slightly different on 1-6 pump units.
All settings shown in this instruction manual are for illustration/example only.
!
The settings, which you use must be derived from your own knowledge and experience, combined with
experimentation and the requirements of the installation.
Important
B
L
S
RIGHTSTAR
AUNDRY
YSTEMS
-
E
NTERING
FWD/ACCEPT
FWD/ACCEPT
to select the required option, and
-
S
IGNAL
FWD/ACCEPT
FWD/ACCEPT
to accept your choice
P
M
ROGRAM
key.
00000 BSL10
BRIGHTWELL
UP
and
key to
ENTER CODE TO
CHANGE SETTINGS
see below
A
T
CCEPTANCE
key to
ACCEPTANCE TIME
00 SECONDS
UP
24
ODE
01
1---
SETTINGS
IME
SETTINGS
SIGNAL
E
NGLISH
ENTER CODE TO
EDIT SETTINGS
----
ENTER CODE TO
CHANGE SETTINGS
1111
CYCLE COUNTERS
see page 36
SIGNAL
ACCEPTANCE TIME
01 SECONDS
MAN 1:----------
MAN 2:----------
MAN 3:----------
OFF P:1234567890
B
L
S
RIGHTSTAR
AUNDRY
YSTEMS
Publicité
