Hauff-Technik ESH Basic-FUBO-GK/MBK Instructions D'installation page 31

ESH Basic-FUBO-GK/MBK - Single-line building package
for buildings without a basement
Insert KES pipe system with the adapter pipe into the
9
opening of the transition sleeve, until you hear and feel it
lock in (see Fig.: 10).
Tighten the tightening strap included around the pre-fitted
10
spacer and attach it to the adapter pipe (see Fig.: 11).
Pre-mounted ESH Basic-FUBO-GK with attached KES pipe
►
system and height-adjustable setup device (see Fig.: 12).
Turn around the entire ESH Basic-FUBO-GK and attach to
11
the driven in ground spike (see Fig.: 13).
Should the floor construction be higher than 200 mm,
evenly push down the 3-ribbed seal on the pipe as
well as the water barrier flange on the setup device.
This ensures that the 3-ribbed seal and the water
barrier flange are on the level of the unfinished
floor (see Fig. 14).
The white "unfinished floor upper edge" mark-
ing has no meaning in this case!
Art. Nr.: 5090033074 Rev.: 01/2018-09-05
EN
Fig.: 10
Fig.: 11
Fig.: 12
Fig.: 13
Fig.: 14
31