Setting The Strip Length; Setting The Strip Depth - WDT AVG 0160 Mode D'emploi

AVG 0160
- Insert the end of the cable which has to be stripped into the centering guide until stop.
- Keep hold of the cable.
- Depress the foot pedal and pull the cable end out of the Strip and Twist Machine AVG 0160.
- Keep the foot pedal pressed until you have pulled the cable end out of the centering guide.
INFORMATION:
The more slowly the cable end is pulled out off the machine, the stronger it is twisted.
9.1

Setting the Strip Length

- Unscrew locking ring of adjustable screw at
back of machine
Turn screw to set strip length required
-
(Fig. 9.01)
- Tightening locking ring
- Check length
9.2

Setting the Strip Depth

- Choose suitable adjusting bush according to
O/D of insulation
- Loosen knurled screw in centre of revolver
head (Fig. 9.02)
- Set the position of revolver head according to
outer diameter of insulation (Fig. 9.03)
- Now tighten knurled screw (Fig. 9.02)
Page 33 / 62
Version 05/10
Fig. 9.01
Fig. 9.02
Fig.9.03