Comissioning; Connections Et Set Up - WDT AVG 0160 Mode D'emploi

AVG 0160
INFORMATION:
When the operator is positioned in the front of the machine the pedal should be placed
in a comfortable position. The pedal should be placed on an anti slip rubber mat. The
foot pedal must be movable, so that the operator has the possibility to change his
position for ergonomic and production needs.
ATTENTION!
Place the cables on the floor so that they do not cause a trip hazard.
Place the foot petal on the floor only. Do not lay the foot pedal in aisles or walk
ways.
CAUTION!
When working with the Strip and Twist Machine AVG 0160, do not wear loose clothing,
jewellery or long, loose hair that can get caught in the Strip and Twist Machine AVG
0160.
8

Comissioning

ATTENTION!
Prior to starting up the Strip and Twist Machine AVG 0160, make sure it is firmly
positioned on a sturdy stand or bench to prevent it from tipping over.
Prior to starting up the Strip and Twist Machine AVG 0160 you have to check the
condition of the connecting cables. The cables must not show any damage.
Damages have to be repaired before continuing to work with the machine.
CAUTION!
When working with the Strip and Twist Machine AVG 0160, do not wear loose clothing,
jewellery or long, loose hair that can get caught in the Strip and Twist Machine AVG
0160.
8.1

Connections et Set Up

DANGER!
Select the right voltage with the mains changeover switch!
Use a mains cable with a mains plug of your norm (with safety plug).
Page 31 / 62
Version 05/10