Table des Matières
Publicité
EN
M
•
For factory built panel vans, there is no "range" in which
you can choose between different mounting heights. The
mounting plates are tailor made to one specific brand of
vehicle, and in most cases even to one specific wheel-
base within one and the same brand. As a result, the
mounting plates and the fitting drawing supplied with the
HTL will suit only one specific type of vehicle.
•
Lay the mounting plates ready on the ground, and position
the HTL frame on a wheeled fitting jack or fork lift, that will
later be used to slide the HTL frame under the vehicle
chassis. [See Fig. 3.3]
•
Loosen the 2 hexagonal bolts and locking nuts
(1 left & 1 right) that serve as mechanical stops
for the lift arms, so that they can be easily ad-
justed in the finishing stage of the fitting proc-
ess, when the frame is fitted under the vehicle
chassis, and access becomes more awkward.
[See Fig. 3.4]
DHOLLANDIA
3.3
15
3.4
!
Publicité
Table des Matières
