R&G LP0182BK Instructions De Montage page 9


Gently lower the licence plate bracket while feeding the wiring through the under-tray as
shown in picture 16.

With the licence plate bracket removed undo and remove the three bolts arrowed in
picture 17, remove the cable cover to allow access to the indicators and wiring plug
sockets.

Disconnect the two plug sockets show in picture 18 (it is a good idea to mark which one
Page | 9
comes from which side for reassembly later).
If reusing the original indicators

Remove the screw arrowed in picture 19 and then the clamp plate.

Remove the spreader plate as shown in picture 20, and then squeeze the rubber indicator
stem to allow the indicator to be removed.

Repeat the above to remove the other indicator.

Fit the indicators to the indicator mounting bracket (item 8) as shown in pictures 21, 22,
23 and 24 in the same manner as they were mounted originally (ensure they are fitted on
the correct sides).
If using Mini indicators

If using mini's fit the indicators of choice to the indicator mounting bracket (item 8)
(R&G mini indicator product code RG370 for bulb type and RG371 for LED type or
RG372 for Aero Style led type) using the four indicator adaptors (item 11) (please use the
provided heat shrink (item 12) to protect the wiring) as shown in pictures 25 and 26.

Fit the new licence plate illuminator (item 10) to the new licence plate bracket (item 1) as
shown in pictures 27 and 28 (please use the provided heat shrink (item 12) to protect the
wiring).

PLEASE NOTE YOU WILL NEED TO GLUE THE LIGHT SHROUD TO THE
LED LICENCE PLATE ILLUMINATOR USING SUPER GLUE.

Place the shaped mounting spacer (item 2) onto the licence plate mounting bracket (item
1) as shown in picture 29, use the bolts to align correctly.

Cut and stick the self-adhesive foam (item 14) to the upper surface of the licence plate
mounting bracket (item 1) as shown in picture 30.

If using indicators fit the indicator mounting bracket (item 8) to the licence plate
mounting bracket (item 1) using the two smaller M6 button head bolts (item 7) as shown
in picture 31 and below.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com Email:
9
LP0182
info@rg-racing.com