R&G LP0182BK Instructions De Montage page 10


Feed all the wires through the square hole in item 1 as shown in pictures 29 and 30.

Fit the cover/cable-tidy (item 9) into position ensure the wires are not trapped or stretched
as shown in picture 33.
Page | 10

Place two of the longer M6 button head bolts (item 3) with washers (item 4) through the
licence plate bracket and shaped mounting spacer as shown below.

Offer this assembly into position as shown in picture 34 while feeding the wires through
the under-tray.

Using two of the M6 nyloc nuts (item 5) with washers (item 4) secure the assembly in
position (do not fully tighten the nuts at this stage).

Position the two remaining M6 button head bolts (item 3) with the remaining M6 washers
(item 4) through the cover/cable-tidy, through the main bracket as shown below.

Using the remaining nuts (item 5) and washers (item 4) secure the assembly into position
(please replace the wiring clamp as original) as shown in picture 35.

Tighten all the nuts ensuring no parts of the assembly come into contact with any of the
original body work.

Connect the licence plate illuminator using the supplied wiring connector (item 16) to the
original wiring plug socket.

If using the original indicators use the original wiring harness (from the original licence
plate bracket) to connect the indicators to the original wiring plug socket. It is a good idea
to check the operation of the licence plate illuminator and indicators at this stage (if the
licence plate illuminator fails to light please swap the bullet connectors over).
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email:
10
LP0182
info@rg-racing.com