R&G LP0182BK Instructions De Montage page 22


Si vous monter les minis clignotants R&G, les fils de clignotants d'origine devront être
« coupés puis fermés » pour réutiliser les connecteurs afin de connecter les mini
clignotants R&G au linceul de feu. Cela s'effectue en coupant les connecteurs des
clignotants d'origine, avant de monter les connecteurs (article 15) sur les fils puis
connecter les clignotants R&G. Branchez le dans le métier à tisser pour vérifier à ce stade
(si l'éclairage échoue, permutez les connexions). (Utilisez svp le manchon thermo
Page | 22
rétractable (article 12) pour protéter les fils de nouveaux clignotants). Il est conseillé de
mettre le contact à ce stade, pouro vérifier le fonctionnement des feux.

Remettre le capot arrière comme à l'origine.

Remettre les 2 carénages internes comme à l'origine

Remettre les 2 carénages externes comme à l'origine

Utiliser les colliers pour organiser les fils

Remettre la plaque (peut nécessiter un perçage).

IMPORTANT: Si vous installez une grosse plaque, il y a un risque que la plaque entre en
contact avec la roue arrière en cas de choc sur la route (bosse, grosse charge etc...). Il
est de votre responsabilité de vérifier que cela ne puisse pas se produire. Ne pas
effectuer ces vérifications peut entrainer des dommages ainsi que des blessures graves
pour le pilote.

Remettre les 2 sièges.

Selon la loi locale, monter les réflecteurs (article 13) aux emplacements appropriés.

Revérifiez que les clignotants et les feux de plaque fonctionnent bien avant de prendre
la route.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they
were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be
in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the
gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No
returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not
refer to faulty goods.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Ces instructions de montage sont disponibles sur
COUPLES DE SERRAGE :
M4 BOULON = 8Nm
M5 BOULON = 12Nm
M6 BOULON = 15Nm
M8 BOULON = 20Nm
M10 BOULON = 40Nm
ISSUE 1 22/05/2015 (NSY)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
www.rg-racing.com
R&G Racing
www.rg-racing.com Email:
22
LP0182
info@rg-racing.com