R&G LP0182BK Instructions De Montage page 8

Page | 8
FITTING INSTRUCTIONS

Remove the rider and pillion seat.

Remove the four bolts arrowed in pictures 1, 2 and 3 and remove the right hand side outer
panel.

Remove the three bolts arrowed in picture 4 and remove the right hand side inner
mounting panel.

Remove the four bolts arrowed in pictures 5, 6 and 7 and remove the left hand side outer
panel.

Remove the three bolts arrowed in picture 8 and remove the left hand side inner mounting
panel.

Undo the tool kit clasp and remove the tool kit as shown in picture 9.

With both side pods removed undo and remove the 2 bolts arrowed in picture 10.

Remove the two bolts
seat cowl.

Disconnect the three wiring plug sockets shown in pictures 13 and 14.

Unclip the wiring clamp and remove the four bolts arrowed in picture 15 whilst
supporting the original licence plate bracket from underneath.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 33
PICTURE 35
and push rivets arrowed in pictures 11 and 12 and remove the rear
R&G Racing
www.rg-racing.com Email:
8
LP0182
PICTURE 34
info@rg-racing.com