Method Of Use; Charging The Battery - Trek RIDE+ Manuel Du Propriétaire

Method of use

„ Charging the battery
1.
Attach the charger plug to the charger connector of the
battery.
Insert it with the groove side of the connector facing
up.
* You cannot insert it with the groove side facing
down.
DANGER
• Use the battery and charger combination specified by the
company for charging and follow the charging conditions
specified by the company. Not doing so may cause
overheating, bursting, or ignition of the battery.
• You cannot use the battery immediately after purchase. Before
riding, be sure to charge the battery until it is fully charged.
• If the bicycle is stored for an extended period of time
immediately after purchase, you will need to charge the
battery before using the bicycle. Once the battery is charged,
it starts to deteriorate.
2.
After charging has started, the LED lamp on the charger
lights up.
You can check the current charging status on the
battery level lamp located on the battery.
Charging (Within 1 hour after the
completion of charging)
Lights up
Charging error
Flashing
Battery disconnected
(1 hour or more after the completion of
Turned
off
charging)
<BT-E6000>
Charger connector
Groove
<BT-E6010>
Groove
Charger LED lamp
Battery level lamp indication
EN-11
Battery
Backside (no groove)
Charger connector