Trek RIDE+ Manuel Du Propriétaire page 36

Masquer les pouces Voir aussi pour RIDE+:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Battery
Symptom
All the five battery level
indicators stay on.
The battery quickly loses its
charge.
The battery cannot be
recharged.
The battery does not start
recharging when the
charger is connected.
The battery and charger are
becoming hot.
The charger is warm.
The LED on the charger
does not illuminate.
The battery cannot be
removed.
The battery cannot be
inserted.
Fluid is coming out from the
battery.
An abnormal odor can be
detected.
Smoke is coming out from
the battery.
Cause / Possibility
The battery level indicators do not show
battery levels when the battery is
connected to the bicycle. Battery levels are
shown during charging.
The battery may be at the end of its service
life.
Is the power plug of the charger securely
inserted into the electrical outlet?
Is the recharging plug of the charger
securely inserted into the battery?
Are the connection terminals of the charger
or the battery dirty?
The battery may be at the end of its service
life.
The temperature of the battery or charger
may exceed the operating temperature
range.
If the charger is being used continuously to
charge batteries, it may become warm.
Is the recharging plug of the charger
securely inserted into the battery?
Is the battery fully charged?
EN-33
Remedy
It is not a sign of a malfunction.
Replace the battery with a new one.
Disconnect and then reconnect the power
plug of the charger, and then repeat the
recharging operation.
If the battery still cannot be recharged,
contact the place of purchase.
Disconnect and then reconnect the
recharging plug of the charger, and then
repeat the recharging operation.
If the battery still cannot be recharged,
contact the place of purchase.
Wipe the connection terminals with a dry
cloth to clean them, and then repeat the
recharging operation.
If the battery still cannot be recharged,
contact the place of purchase.
Replace the battery with a new one.
Stop recharging, wait for a while and then
recharge again. If the battery is too hot to
touch, it may indicate a problem with the
battery. Contact the place of purchase.
Wait a while before using the charger
again.
Check the connection for any foreign
objects before reinserting the charging
connector. If there is no change, contact
the place of purchase.
If the battery is fully charged, the LED on
the battery charger turns off, but this is not
a malfunction. Disconnect and then
reconnect the power plug of the charger,
and then repeat the recharging operation.
If the LED on the charger still does not
illuminate, contact the place of purchase.
Contact the place of purchase.
Contact the place of purchase.
Contact the place of purchase.
Stop using the battery immediately and
contact the place of purchase.
Stop using the battery immediately and
contact the place of purchase.

Publicité

Table des Matières
loading

Table des Matières