Sharp XE-A203 Manuel D'instructions page 54

5. Preset rate entry programming (Press
(1) Go to (2) when the preset rate entry does not need
to be changed from "PRESET ENABLE".
Otherwise, press
DISABLE".
:
Each time key is pressed, the display shows "PRESET
DISABLE" and "PRESET ENABLE" alternatively.
Default setting is "ENABLE".
s
(2) Press the
Immediately after displaying guidance message for
the next step, the current setting for the next step
will be displayed.
6. Position of decimal point programming (Press
(1) Enter the position of decimal point from right using
numeric key.
The position of decimal point from right can be set
from 0 to 3.
Default setting is 2.
s
(2) Press the
7. Terminate programming
A
(1) Press the
programming.
Item:
A Open rate entry
B Preset rate entry
C TAB (position of decimal point from right)
Programming for
X
The key is used as an example below.
r
Programming for
1. Specify the key to program.
X
(1) Press the
Immediately after displaying "CH1 PROGRAMMING",
52
guidance message for the next step will be displayed.
:
key to display "PRESEST
key to register the setting.
key to register the setting.
key to terminate the
r R X
, ,
R
and , the step 3 and 4 are skipped.
X
key to enter programming.
s
to skip. / Press
s
to skip. / Press
V
key
Selection:
Enable*
Disable
Enable*
Disable
Y c b
, , and
Key operation
A
to terminate.)
s
TAB
A
to terminate.)
2
s
ENTER[TL/NS]KEY
A
Print
Text Rate
Print:
0
1
0
1
0-3 (default:2)
Operator display
X
CH1 PROGRAMMING
ENTER[00]KEY
2
2
0.00
From left, ABC