Sharp XE-A203 Manuel D'instructions page 81

The details of the register system modification are as shown below:
Items
General Z1 report
General Z2 report
GT memories (GT1, GT2, GT3 and Training GT)
Conversion of preset prices of Dept./PLU
Conversion of entry digit/amount limit
Exchange amount printing for total and change
Exchange calculation method
Domestic currency symbol
Domestic currency decimal point position
Exchange currency symbol
Exchange currency decimal point position
Rounding system (Denmark/Sweden/Normal)
Rounding up/down of the unit digits of amount
Lowest digit entering limitation of item
Lowest digit entering limitation of payment
Memory of difference due to rounding
Rounding of exchange currency
• The item marked with "-" remains the same as the previous data.
*1: When you perform from EURO status 2, previous data remains unchanged.
*2: When you perform from EURO status 1 or 2, "space" is set.
IMPORTANT
• Conversion of the preset unit prices of departments and PLUs
Note that the conversion rate of the preset rate of the
set to "division". When the conversion is performed, the message "PRICE CONVERTED" will be printed on the
#800 report.
• After the execution of the procedure with "A=1", treat EURO as foreign currency using the exchange key (
with the preset rate entry. Set the EURO conversion rate as the currency exchange rate for the exchange key.
• After the execution of the procedure with "A=2", treat EURO as domestic currency, and national currency as
foreign currency using the exchange key (
currency exchange rate for the exchange key.
• As for the percent rate for
currency becomes EURO, you must change these settings so that they are base on EURO currency.
You can manually make these settings. For programming details, please refer to "EURO
Programming" section.
A=1
(EURO status 1) (EURO status 2)
Issue
Issue
-
-
-
Yes
Division
-
-
[EURO]
2
-
-
-
-
-
Round off
(4 down/5 up)
V
) with the preset rate entry. Set the EURO conversion rate as the
% & -
, and , the automatic conversion is not made. So, when your domestic
1 2 3
Part Part Part
A=2
Issue
Issue
Clear
Yes
Yes
Yes
Multiplication
[EURO]
2
Previous domestic currency
symbol
Previous domestic currency
decimal point position
Normal
No
Arbitrary
Arbitrary
No
Round off
V
key is applied for the conversion, and the method is
FOR THE MANAGER
A=3
(EURO status 3)
Issue
Issue
Clear*1
Yes*1
Yes*1
No
Multiplication
[EURO]
2
-*2
-
Normal*1
No*1
Arbitrary*1
Arbitrary*1
No*1
Round off
V
)
79