Entering Character Codes With Numeric Keys On The Keyboard - Sharp XE-A203 Manuel D'instructions

Example 2: Job code type programming (programming starting from the press of
Key operation example
Job code entry
¥ Guidance message is displayed.
Parameter entry
Registration of parameter
To terminate

Entering character codes with numeric keys on the keyboard

For entering numerals, letters or symbols, enter a character code using numeric keys and press the numeric key
For the character codes, please refer to the alphanumeric character code table on the next page. By doing this,
you can program characters other than those on the key tops. For entering numerals and letters using character
keys, refer to "Using character keys on the keyboard" on page 13.
• Double-size characters can be made by entering the character code 253 or pressing the
displayed when double-size characters entry is selected as shown in the operator display example below.
• All three digits of the character code MUST be entered (even if it starts with zero).
Key operation example
To program the word "SHARP" in double-size characters
253
44
s
1
s
A
253
: : :
083 072
S H
@
MACHINE NO.
50
ENTER[TL/NS]KEY
Cursor
:
_
Characters entered are displayed here.
065
:
=A_
Characters: Indicating double size character of "A"
: :
065 082 080
A R
s
.)
Operator display
To repeat
(depending on programming)
50
Guidance message is changed
after a new job code entry.
0.00
W
key. "W" is
Operator display
W
065
Character code
W
:
P
:
.