Installing Batteries - Sharp XE-A203 Manuel D'instructions

2

Installing Batteries

Three new alkaline batteries LR6 ("AA"size) must be installed in the cash register to prevent the data and
user-programmed settings from being erased from the memory, when the AC cord is accidentally disconnected
or in case of power failure. Once installed, the batteries will last approximately one year before needing
replacement. At this time, the warning message "LOW BATTERY" will appear on the display to indicate the
batteries are low and must be replaced within two days. If the warning message "NO BATTERY" appears, you
must install the batteries at once. Do not set the mode switch to the
BATTERY" is being displayed.
Install three new alkaline batteries LR6 ("AA"size) according to the procedure shown below with the AC cord
connected and set the mode switch to the REG position:
1.
Push the printer cover forward and detach it.
Be careful with the paper cutter, so as not to cut yourself.
2.
Open the battery compartment cover next to the paper roll cradle.
3.
Install three new alkaline batteries LR6 ("AA"size) as per the diagram.
When the batteries are properly installed "NO BATTERY" message on the
display will disappear.
4.
Close the battery compartment cover.
• Be sure to observe precautions shown on page 1 when handling
batteries.
• If you press a key by mistake, an error message "PAPER EMPTY"
may be displayed. Press the
installing paper rolls.
"LOW BATTERY" or "NO BATTERY" can be displayed only when the cash register is being turned
on. Please be advised that when the cash register is being turned off for a long time, the data in
memory might be cleared without the warning messages: "LOW BATTERY" or "NO BATTERY".
1
QUICK START GUIDE
Part
l
key to clear message after
, nor PGM positions while "NO
2 3
Part Part
9