Setting The Dip Switch; Scsi Id Setting - Sony UP-D2550S Mode D'emploi

Setting the DIP Switch

12
Preparation
The DIP switches on the rear panel determine the on/off state of the internal SCSI
bus terminator and SCSI device ID number.
ON
4 2 1
1
0
OFF
SCSI ID
Terminator
Terminator ON/OFF setting
If the printer is located at the physical end of the SCSI bus, this switch should be
set to ON. Otherwise, if another device is at the end of the bus, this switch should
be OFF.
Switch ON
Terminator The internal terminator is ON.

SCSI ID setting

The SCSI ID selection must be different from any other device on the bus. If two
SCSI ID devices have the same ID, a malfunction will occur.
SCSI ID SCSI ID switch
4 2
0 0 0
1 0 0
2 0 2
3 0 2
4 4 0
5 4 0
6 4 2
7 4 2
OFF
The internal terminator is OFF.
1
0
1
0
1
0
1
0
1