Electric Connection; Gas Change - VITROKITCHEN 301TGN Livre D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Technical specifications:
The hob has a turning on and control system based on very low voltage electric energy (4
Volts) and does not require electric shock protection systems, so it does not need to be earth
connected.
A power supply of 220V should be available to keep the hob functions and load the power
supply of the same, which must be placed out of the heat areas and far from the gas network,
in accordance with the Gas Appliances Installation Regulation, preferably at the lower rear
part of the furniture and at a distance of less than 1.5m from the front of the hob.
Functioning Autonomy:
This glass ceramic hob is the only one in Europe with functioning autonomy thanks to,
in the event of a failure in the supply of electricity, the fact that this has rechargeable
batteries with a practically minimum consumption. The necessary starting up is possible,
as well as having all the functions active and guaranteeing the perfect efficiency of all the
safety systems.
The power supply includes a fuse inside, acting as protection. The energy from this socket is
for the exclusive use of the hob.
Important:
For the electric connection of this hob please
follow the instructions below:
1.
Before placing the hob in its hole, connect
the cable to the same.
2.
Plug it in to the electricity supply.
3.
Connect the cable to the socket.
The cable should never be connected to the socket
if this is not connected to the electricity supply.
To change this, disconnect the cable from the socket, disconnect this from the mains, and
replace the socket with a new one. Connect the socket to the mains and plug in the cable to
the socket. See graphic 30.
Contact your distributor to purchase a new power socket. The power socket should never be
opened if this is not disconnected from the mains.
The gas change must only be carried out by the Official Technical Service.
Upon supplying the parts destined for adaptation to another type of gas or another pressure
to the Official Technical Service, the manufacturer will supply sufficient and clear
indications for the replacement of the parts, as well as for their cleaning, adjustment, and
checking of the appliance and replacement of the seals after the change.
Together with the adaptation parts, the manufacturer will provide a new adhesive plate, to be
stuck on the appliance where the nature and pressure of the gas installed by the Official
Technical Service and noting its history.

ELECTRIC CONNECTION

GAS CHANGE

13
Graphic 30

Publicité

Table des Matières
loading

Produits Connexes pour VITROKITCHEN 301TGN

Ce manuel est également adapté pour:

101tgb

Table des Matières