VITROKITCHEN 301TGN Livre D'instructions page 30

2.1) Fixing the hob in the space provided.
Place the hob upside down on a clean table, remove the
protection of the two sealing strips and stick them on the
external frame of the hob. Graphics 19 and 20.
Do not use silicone under any circumstances as sealant
between the hob and the kitchen top. If this is used, the
manufacturer is not responsible for the damage made to
the cooking hob.
Depending on the work top thickness (A) two rear hooks
should be placed, as shown in graphics 21 and 22.
First holes for top of 20mm.
Second holes for top of 30mm.
Third holes for top of 40mm.
Fourth holes for top of 50mm.
Introduce the hob in the top hole, push towards the
wall for the hooks to enter the lower part of the
same, place it on the top in such a way that this rests
completely on it, fixing, in this way, its rear part.
To fix the front part (See graphic 23), screw on the
top body the 2 fixing brackets, found inside the
packaging, in such a way that acting as end stop with
the top levels and fixes the hob.
Graphic 23
2.2) Connection to gas network.
Make sure that the hob can use the gas that is available.
The hob is prepared for a ½ inch connection for gas with a
metal filter to avoid the remains of the installation and gas
impurities reaching the hob. See graphic 24. This should be
connected in accordance with the current official
regulations by an authorised person. See graphic 25. (Rigid
connection)
of thickness
Graphic 21
Graphic 22
11
Graphic 19
Graphic 20
Graphic 24