Publicité
Les langues disponibles
Les langues disponibles
Kia Picanto
2004 - ....
Ref. 1458
Fitting instructions
1)
Disassemble the rear-light units and the bumper. Permanently remove the bumper holders on the buffer
beam. Cut out a small triangle in the right inner wing (see photo).
2)
Place the side plates (6) and (7) on the outside of the chassis beams and mount loose by (B).
3)
Place the tow bar between the side plates and mount loose by (B) and (C).
Tow bar with standard ball is to be mounted by (*) and (*'). Adjust the tow bar and tighten everything
4)
firmly.
5)
Re-assemble the disassembled parts. Before assembling the bumper, cut out a small piece according to
enclosed drawing.
Composition
Tow bar reference 1458
1 ball T45L001
4 bolts M12x70 - DIN931
4 security nuts M12 - DIN985
2 mounting tubes T45
2 mounting pieces T45
1 security shackle (-s)
2 bolts M12x30x1,25 - DIN961
2 bolts M12x45x1,25 - DIN961
4 bolts M12x35 - DIN933
6 security washers M12 - DIN128A
8 washers ø24x13x2,5mm
2 nuts M12 - DIN934
1 socket holder P07
All bolts and nuts : quality 8.8
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(*-*')
(*-*')
(*)
(*)
(*')
(E)
(D)
(C-B)
(E-D-C-B)
(E-D-C-B)
(C)
(*')
Publicité
