AYA ADW09000A+W Instructions D'utilisation page 47

3 mm
10 mm
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly into the sink. It will
be necessary to drain excess water from hoses into a bowl or suitable container that is held outside and lower
than the sink.
10 mm
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water drain hose is not kinked or squashed.
10 mm
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
10 mm
Syphon Connection
The waste connection must be at a height of between 40 cm (minimum) and 100 cm (maximum)
of the dish. The water drain hose should be fixed by a hose clip. The free end of the hose must not be immersed
in water.
10 mm
Start of Dishwasher
10 mm
The following things should be checked before starting the dishwasher.
1. The dishwasher is level and fixed properly
2. The inlet valve is open
3. There is a leakage at the connections of the conducts
4. The wires are tightly connected
5. The power is switched on
6. The inlet and drain hoses are knotted
7. All packing materials and printings should be taken out from the dishwasher
10 mm
Attention:
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
-43-
3 mm
from the bottom