Installation Instruction - AYA ADW09000A+W Instructions D'utilisation

3 mm
10 mm

7.Installation instruction

10 mm
Positioning the Appliance
10 mm
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate proper installation.
Levelling the Appliance
About Power Connection
10 mm
WARNING!
For personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE EARTHING CONNECTION FROM THE POWER
CORD.
10 mm
Electrical Requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the appropriate power
supply.Use the required fuse 10 amp, time delay fuse or circuit breaker recommended and provide separate
circuit serving only this appliance.
Insure proper
ground exists
before use
10 mm
GROUNDING INSTRUCTIONS
10 mm
This appliance must be earthed. In the event of a malfunction or breakdown, earthing will reduce the risk of electric shock
by providing a path of least resistance for the electric current. This appliance is equipped with a cord having an equipment
-earthing conductor and an earthing plug. The plug must be plugged into an appropriate outlet that is installed and earthed
in accordance with all local standards and requirements.
10 mm
WARNING!
Improper connection of the equipment earthing conductor can result in the risk of an electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the appliance is properly
earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet, please have
a qualified electrician to install a proper outlet.
Once the appliance is positioned for levelling, the height of the dishwasher
may be altered via adjustment of the screwing level of the feet. In any case,
the appliance should not be inclined more than 2 .
Electrical Connection
Ensure the voltage and frequency of the power being corresponds to those on the rating
plate. Only insert the plug into an electrical socket which is earthed properly. If the electrical
socket to which the appliance must be connected is not appropriate for the plug ,replace
the socket, rather than using a adaptors or the like as they could cause overheating and
burns.
-41-
3 mm