AYA ADW09000A+W Instructions D'utilisation page 46

3 mm
10 mm
Water Connection
10 mm
Cold Water Connection
WARNING!
please close the hydrant after using.
10 mm
Drain hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to
avoid bending or crimping it. Use the special plastic support that comes with the appliance . The top of the hose
must be at a height between 40 and 100cm. The free end of the hose must not be immersed in water to avoid the
back flow of it.
10 mm
Close the drain hose hook to the counter
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water inlet to be blocked and damage the appliance.
PLEASE HANG UP THE DRAIN HOSE EITHER WAY OF A, B, C
Front
Drain pipe
A
B
C
-42-
Drain hose hook
Counter
φ 40mm
3 mm