AYA ADW09000A+W Instructions D'utilisation page 41

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3 mm
10 mm
NOTE:
When you press the Start/Reset button to pause during washing, the running indicator light will stop blinking
and the dishwasher will mooing every minute unless you press the Start/Reset button to start.
10 mm
Change the Program
10 mm
Premise
1. A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.If this
is the case, the detergent dispenser must be refilled (see the section entitled " Loading the Detergent " ).
2. When you press the start/reset button more than 3 seconds, you can cancel the running programme and
select other programmes (see the section entitled " Starting a wash cycle. . . " ).
3. When you select Normal/Eco.Programmes, you can select the All in1 function.
4. The Display window shows the state of the dishwasher:
a) Running indicator light is off ----------------------------------> stand by;
b) Running indicator light is on and not blinking -------------> pause;
c) Running indicator light is on and blinking ------------------------> run.
NOTE:
If you open the door
and the buzzer will mooing every minute unless you close the door .
After you close the door ,the machine will keep on working after 10 seconds.
Forgot to Add a Dish?
10 mm
A forgotten dish can be added any time before the detergent cup opens.
1. Press the start/reset button
2. Open the door a little to stop the washing.
3. After the spray arms stop working,you can open the door completely.
4. Add forgotten dishes.
5. Close the door
6. Press the start/reset button, the dishwasher will run after 10 seconds.
10 mm
At the End of the Wash Cycle
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
WARNING!
during a wash cycle
, the machine will pause. The running indicator light will stop blinking
It is dangerous to open the door when washing, because the hot water may scald you.
-37-
3 mm

Hide quick links:

Publicité

Chapitres

Table des Matières
loading

Table des Matières