AYA ADW09000A+W Instructions D'utilisation page 33

3 mm
10 mm
B. Loading the Salt Into the Softener
10 mm
Always use the salt intended for use with dishwasher.
The salt container is located beneath the lower basket and should be filled as explained
following:
Attention!
Only use salt specifically designed for the use in dishwashers! Every other type of salt not
Specifically designed for the use in a dishwasher, especially table salt, will damage the water
Softener. In case of damages caused by the use of unsuitable salt the manufacturer does not
give any warranty nor is liable for any damages caused.
Only fill with salt just before starting one of the complete washing programs.
This will prevent any grains of salt or salty water, which may have been spilled, remaining on the
bottom of the machine for any period of time, which may cause corrosion.
10 mm
10 mm
A. Remove the lower basket and then unscrew and remove the cap from the salt container.1
B. Place the end of the funnel(supplied) into the hole and introduce about 1.5kg of dishwasher salt.
C. Full fill the salt container with water.It is normal for a small amount of water to come out of the salt container. 2
D. After filling the container , screw the cap tightly back clockwise.
E. Usually, the salt warning light will stop being illuminated within 2-6 days after the salt container has been filled
with salt.
F. Immediately after filling the salt into the salt container, a washing program should be started (We suggest to use
the soak or rapid program). Otherwise the filter system, pump or other important parts of the machine may be
damaged by salty water. this is out of warranty.
NOTE:
1. The salt container must only be refilled when the salt warning light in the control panel comes on.
2. If there are spills of the salt, a soak or a rapid program should be run to remove the excessive salt.
C. Fill the Rinse Aid Dispenser
10 mm
Rinse Aid Dispenser
The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes, which can leave
spots and streaks. It also improves drying by allowing water to roll off the dishes. Your dishwasher is designed to use
liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser.
To fill the dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turns completely
black. The volume of the rinse aid container is about 110ml.
Open
Depending on how well the salt dissolves, the salt warning light may still be on even though the
salt container is filled.
If there is no salt warning light in the control panel (for some Models),you can estimate when to fill
the salt into the softener by the cycles that the dishwasher has run.
-29-
3 mm
in the