Prior Using For The First Time - AYA ADW09000A+W Instructions D'utilisation

3 mm
10 mm

3.Prior using for the first time

10 mm
Before using your dishwasher for the first time:
A. Set the water softener
B. Add 1.5Kg dishwasher salt and then full fill the salt container with water.
C. Fill the rinse aid dispenser
D. Fill in detergent
10 mm
A. Water Softener
10 mm
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would have a detrimental or
Adverse effect on the operation of the appliance. The higher the content of these minerals and salts, the harder
your water is. The softener should be adjusted according to the hardness of the water in your area. Your local
Water Authority can advise you on the hardness of the water in your area.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of
the water used. This is intended to optimise and customise the level o f salt consumption.
dH
0~8
8~22
22~45
45~60
10 mm
Note:1
° 1
dH=1.25 Clarke=1.78 fH=0.178mmol/l
° DH:
° fH:
Clark: British degree
°
Contact your local water board for information on the hardness of your water supply.
NOTE:
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form
on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt container specifically designed to eliminate
lime and minerals from the water.
WATER HARDNESS
fH Clarke
0~10
0~14
10~28
14~39
28~56
39~80
56~75
80~107
° °
German degree
French degree
If your model does not have any water softener, you may skip this section.
Please follow the steps below for adjustment in salt consumption.
1. Unscrew the cap from the salt container.
2. There is a ring on the container with an arrow on it (see figure
on the side), if necessary, rotate the ring in the anticlockwise
direction from the "-" Setting toward the "+" sign, based on the
hardness of the water being used.
It is recommended that adjustments should be made in
accordance with the following scheme:
Selector Position
mmol/l
0~1.4
/
1.4~3.9 -
3.9~8 Mid
+
8~11
-28-
Salt c onsumption Auto nomy
(gram/cycle) (cycles/1kgs)
0
20
40
60
Note:2
" " / No salt need added
"-" Setting toward the"-" sign
Setting toward the"+" sign
"+"
Setting toward between
"Mid"
the "-" sign and "+" sign
3 mm
/
50
25
16