Krick Modelltechnik COMTESSE Instructions De Montage page 53

Fig. drive
Finally glue in the RC board.
At the position of the motor the servo was re-
moved before. Therefore now a new mounting
for the servo must be placed.
Now the installation of the drive is finished.
Now the bracket and the rudder servo can be
installed.
Fig. laser board and finished servo mount
Place the servo in the bracket and position
both on the side of the RC board. Fasten the
bracket to the RC board with 2 screws A-16.
Status September 2018
Fig. servo mount with servo
Hook in parts 2.7 and 3.12 and connect them
with the two set collars.
Fig. connection servo and rudder
Page 23 ©
Krick Modelltechnik, Knittlingen, Germany