Publicité
Les langues disponibles
Les langues disponibles
Fig. front reinforcement board
After gluing parts 1.2 and 1.3, insert the hexa-
gon nut M3 and glue part 1.4 to the end. Make
sure that no adhesive gets into the thread.
1.5
Fig. front reinforcement board with nut M 3 and
eyebolt M 3
Coat the upper side of board 1.2 with Stabilit-
Express. Insert the board with the handle into
the hull and screw the eye bolt 1.6 through the
deck from above to secure and tighten. Clamp
the handle to the edge of the sliding hatch until
the adhesive has cured. Make sure that no
glue gets to the screw thread, otherwise the
eyebolt is stuck and cannot be loosened any
more. After the adhesive has dried, break off
the handle at the predetermined breaking
points.
Status September 2018
1.2
1.3
1.4
1.6
Page 4
Fig. reinforcing board in position
Now also make the lateral reinforcement
boards for the shroud fastening in the same
way from parts 1.10 to 1.12.
Fig. lateral reinforcement boards
Now the main bulkhead can be made with the
mast mounting from parts 1.7 to 1.9.
1.9
Fig. parts main bulkhead
First glue part 1.8 to part 1.7 at the marked
point. Then glue both parts 1.9 from the front
and rear over the cutout.
Now paint the frame and the reinforcement
boards several times with pore filler.
©
Krick Modelltechnik, Knittlingen, Germany
1.8
1.7
Publicité
