Publicité
Les langues disponibles
Les langues disponibles
Fig. motor mount assembled
Screw the motor into the motor mount and
secure the coupling with shaft to the motor.
Now make the lubrication of the shaft with the
plastic lubricating nipple fixed to the stern tube.
Fig. lubrication nipple
Fig. lubrication nipple with sterntube
Screw on the lubrication nipple 15mm before
the end of the sterntube and fix it on the stern-
tube with superglue.
Status September 2018
Abb
Fig. Drill lubrication hole in sterntube
Now use the guide of the grease nipple and
drill through the sterntube.
Fig. mounted drive
Slide the complete unit into the hull and align it.
It is important to ensure that the complete unit
runs smoothly without force. Align the adjust-
able motor mount and tighten the screws. If
smooth running is guaranteed, the gluing can
be started. Use Stabilit Express for this pur-
pose. First glue the sterntube into the hull.
After the adhesive has cured, check the
smooth running again and then glue the en-
gine mount with Stabilit Express.
Fig. separating for the drive
Cut out the servo area on the RC board at the
markings.
Fig. Placing the drive in the hull
Now place the complete propulsion unit in the
hull and align it.
Page 22
©
Krick Modelltechnik, Knittlingen, Germany
Publicité
