Publicité
Les langues disponibles
Les langues disponibles
Cut the rotation axis to length, put it into the
rung 10.7 with the same protrusions left and
right and solder it in - drawing "10B".
Bend the bathing ladder according to drawing
"10B" according to the stern bevel.
Place the bathing ladder on the transom and
align it with the stern pulpit.
Mark and drill the holes for the split pins 10.9.
Push the split pins onto the axis of rotation,
place them in the transom and fix them with
superglue. The bathing ladder must remain
swivel-mounted.
Turn the bathing ladder upwards. Insert the
axle 10.10 into the rung 10.11, which has been
cut exactly to length. Bend the ends down-
wards at right angles. Drill two 1 mm holes
directly below the middle rung 10.6.
Insert the axle into the holes on the transom
and glue it in place so that the bathing ladder is
locked in place when the transom flaps up.
Fig. bathing ladder folded down, additional
rung
Fig. bathing ladder folded up, locked in position
Status September 2018
Stage 11, fittings and finishing work
Steering column and steering wheel
Make the steering column with steering wheel
from parts 4.2 - 4.11.
4.7
4.3
4.2
4.5
Fig. parts steering column
Slide parts 4.3 and 4.4 into each other so that
a 3 mm recess is made at the top to accom-
modate the compass rose and the compass
glass. Push both parts onto the steering col-
umn 4.2 in such a way that a flush support is
created on the inside. Cut out the compass
rose and glue it onto the base 4.9. Glue both
into the compass housing.
Slide the foot 4.5 onto the bottom of the
compass column. Then push the flange 4.6
onto the bottom and glue it in place.
Finally, glue in the compass glass. For this
purpose Tacky Glue, order number 44085 can
be used.
Fig. finished steering column
Glue the steering wheel 4.10 to the axle 4.11.
Drill a 2 mm hole in the steering column and
insert the steering wheel.
Page 17
©
4.8
4.9
4.4
4.6
Krick Modelltechnik, Knittlingen, Germany
Publicité
