Kozy Heat Fireplaces ALP-36 Manuel D'utilisation page 15

10. Install cap into the wall and attach the cap to the wall using the
eight screws provided. See Figure 3.20.
NOTE: Be careful not to tear the gasket on the mounting flange on the
#KPV back assembly during re-assembly in Step 12.
11. Reinstall the #KPV back assembly that was removed in Step 1 of
Section 3.5.
12. Once the cap is fastened to the wall, apply a bead of silicone
(with a minimum of 300°F continuous exposure rating) around
the cap base. See Figure 3.21.
13. Reinstall cap cover using four screws removed earlier.
Figure 3.18, Silicone Weather Sealing
Figure 3.19, Silicone Backside
Kozy Power Vent #KPV R.5
SILICONE (with a min. of 300°F
continuous exposure rating)
ALL (4) SIDES
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
Figure 3.20, Install Cap into Wall
Figure 3.21, Silicone around the Cap Base
FRAMING AND CLEARANCES 15