Installing Vent Cap - Kozy Heat Fireplaces ALP-36 Manuel D'utilisation

3.5 Installing Vent Cap

1. Remove the eight screws securing the back assembly to the cap.
See Figure 3.6.
2. Slide the exhaust assembly out of the back of the cap. See Figure
3.7 and Figure 3.8.
3. Remove the two corrugated shipping pads. See Figure 3.9.
4. Install #KPV wiring harness through the electrical access hole in
the back cover cap. See Figure 3.10 and Figure 3.14.
Instructions continue on the next page.
Figure 3.6, Remove Back Assembly
Figure 3.7, Removing Exhaust Assembly
Kozy Power Vent #KPV R.5
Figure 3.8, Exhaust Assembly Removed
Figure 3.9, Remove Corrugated Shipping Pads
Figure 3.10, #KPV Wiring Harness
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces FRAMING AND CLEARANCES 11