Kozy Heat Fireplaces ALP-36 Manuel D'utilisation page 12

NOTE: Make sure there is no more than 6 inches of wire extending
through the back cap cover. See Figure 3.11.
See Section Figure 3.14, Power Vent Internal Wiring on page 13 for
wiring schematic accompanying these instructions.
5. Attach the red and brown wires to the vacuum switch as shown
in Figure 3.12.
6. Attach the white and black wires from the #KPV harness to the
black wires coming from the blower. Attach the green wire from
the #KPV harness to the green/yellow wire coming from the fab.
7. NOTE: After all wires are connected, the wire should look like the
picture in Figure 3.13.
8. Proceed to Section 3.5.1 Finishing Materials on page 14.
Figure 3.11, Tape Measure Wire
Figure 3.12, Vacuum Switch
12 FRAMING AND CLEARANCES
Figure 3.13, Wires Connected
6" (152mm) max
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
WHITE
BLACK
GREEN
Kozy Power Vent #KPV R.5