Interconnect Cables - Arcam FMJ P777 Manuel

interconnect cables

We recommend the use of high-quality screened cables
that are designed for the particular application. Other
cables will have different impedance characteristics
that will degrade the performance of your system (for
example, do not use cabling intended for video use to
carry audio signals). All cables should be kept as short as
is practically possible.
It is good practice when connecting your equipment to
make sure that the mains power-supply cabling is kept
as far away as possible from your audio cables. Failure to
do so may result in unwanted noise in the audio signals.
CH.7 / SBR
CLASS 2
Ð WIRING
IN OUT
POWER INLET
Power inlet
Check the mains
supply voltage matches
the values printed on
the back panel before
connecting the mains
cable here.
Speaker terminals
The P777 is equipped with seven pairs of
speaker terminals. See page 7 for information
on the different ways of connecting
loudspeakers.
CH.6 / SR CH.5 / RIGHT
4Ð16 4Ð16 4Ð16
OHMS OHMS OHMS
CLASS 2 CLASS 2
+ Ð WIRING + Ð WIRING +
BALANCED BALANCED BALANCED
XLR INPUT XLR INPUT XLR INPUT
XLR XLR XLR
INPUT INPUT INPUT
RCA RCA RCA
SELECT SELECT SELECT
IN OUT IN OUT
AUDIO AUDIO AUDIO
220V
- 240V
50Ð60Hz
1800VA
MAX
12V TRIGGER
IN
12V Trigger input audio input and output
See page 4 for details.
AudIo IN
seven channels.
bi-amplify a set of speakers (see page 7).
input select switch
Depress this switch to take the audio source
from the
each channel; if the switch is not depressed,
the audio source is taken from the
RCA (phono) connector.
CH.4 / CENTRE CH.3 / LEFT
4Ð16 4Ð16
OHMS OHMS
CLASS 2 CLASS 2
Ð WIRING + Ð WIRING +
BALANCED BALANCED
XLR INPUT XLR INPUT
XLR XLR
INPUT INPUT
RCA RCA
SELECT SELECT
IN OUT IN OUT
AUDIO AUDIO
from a pre-amplifier for each of
may be used to
AudIo ouT
e-5
connector for
BAlANcEd XlR INPuT
AudIo IN
CH.2 / SL CH.1 / SBL
4Ð16 4Ð16
OHMS OHMS
CLASS 2 CLASS 2
Ð WIRING + Ð WIRING +
XlR audio input
BALANCED BALANCED
XLR INPUT XLR INPUT
Balanced XLR connectors for each
of seven channels, from an XLR-
XLR XLR
INPUT INPUT equipped pre-amplifier.
RCA RCA
SELECT SELECT
IN OUT IN OUT
AUDIO AUDIO
XLR CONNECTIONS:
PIN1: CABLE SCREEN
PIN2: ÔHOTÕ SIGNAL
2 1
PIN3: ÔCOLDÕ SIGNAL 3