Bowflex TreadClimber TC5500 Manuel Du Propriétaire page 20

Condition/Problem
Condition/Problem Condition/Problem
Unit will not power up/turn
on/start
Speed displayed is not accurate
Heart rate not displayed while
using chest strap
Troubleshooting Troubleshooting Troubleshooting
Things to to to Check Check
Things Things Check
Outlet
Power cord not plugged in
Power switch turned off
Safety key not plugged in
Fuse on motor control board
blown
Display set to wrong unit of
measure. (English/Metric)
Transmitter not making good
contact with skin
Electromagnetic interference
Chest strap transmitter
HR receiver
20
20 20
Solution
Solution Solution
Make sure outlet is functioning
correctly. Verify this by plugging
another object (ex: lamp) into the
outlet. If outlet is connected to a
light switch, check to make sure it
is on. If outlet is not functioning
find a working outlet.
Make sure the power cord is
firmly secured to A/C inlet on the
unit and firmly inserted into a
non-GFI wall socket.
Make sure the power switch at
the rear of the unit is in the "ON"
position. Switch will light up red
to indicate power is present.
Plug Safety Key into Console (See
Emergency Stop Procedure within
the Important Safety Precautions
section).
Contact Customer Care for further
assistance.
Change display units (See Console
Owner's Manual).
Moisten skin contact area on the
chest strap.
Turn off any television, AM
radio, microwave, or computer
within 6 feet (2 meters) of the
TreadClimber ® fitness machine.
Test chest strap with another HR
monitoring device such as HR
watch or a machine at a gym.
If transmitter has good skin
contact and still is not found to be
emitting HR signal, replace chest
strap transmitter.
If chest strap is known to work
with other devices and no sources
of interference are present, or
console has been tested with
a Pulse Simulator and is not
receiving the signal, contact
Customer Care for replacement
HR receiver.