Fein KBB40X Mode D'emploi page 14

OBJ_DOKU-0000002078-003.fm Page 14 Wednesday, July 9, 2014 1:43 PM
en
14
Starting and stopping the drill motor
(figure 8).
Starting:
Switch the motor switch ON.
Stopping:
Switch the motor switch OFF.
Shutting magnet OFF:
Switch off the magnet with the magnet power
switch.
Feed (figure 9).
Feed using the spoke handle.
Instructions for core drilling.
Do not stop the drill motor during the drilling
procedure.
Only remove the cutting tool from the hole
while the motor is running.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hand. Always use a chip hook.
Chips are sharp and hot!
CAUTION
ON switch
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, use a
FEIN ID sharpened cutter for stack drilling.
OFF switch
Spoke handle