Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000069-003.book Page 12 Wednesday, July 9, 2014 1:14 PM
en
12
Changing the tool (figure 5).
Secure the power tool with the
WARNING
safety strap supplied at all
times, especially for work carried out at ele-
vated heights, when drilling horizontally or
above the head. If there is a power loss, or the
power plug is pulled out, the magnetic hold-
ing power is not maintained.
Before mounting or replacing
WARNING
cutting tool or accessories,
pull the power plug. This preventive safety
measure rules out the danger of injuries
through accidental starting of the power tool.
Push the chip guard upward.
Loosen both screws of the tool holder using
the hex key.
Insert the pilot pin into the cutter.
Insert the cutter with the pilot pin into the
tool holder.
Tighten both screws of the tool holder onto
the flats on the cutting tool using the hex key.
Chip guard
Tool holder
Hex key
Hex key
2.
2.
1.
Pilot pin
Cutter
Publicité
