Télécharger Imprimer la page

Segway i2 SE Lower Cargo Frame Manuel D'installation page 15

Masquer les pouces Voir aussi pour i2 SE Lower Cargo Frame:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Universal Water Bottle Mount
24051-00001
Tools required
• 4 mm hex wrench
• Torque wrench
• Electric drill
• 6-8 mm drill bit
Installation
1.
Make sure the PT is powered off and unplugged, and the Standard Case or Power-Pack Case is installed on the Lean Steer.
2.
Using the Water Bottle Holder as a template, mark two drill locations where you will install the Holder. Using a 6-8 mm drill bit, drill
the mounting holes.
NOTE
Be sure you do not drill into any internal components on the Power-Pack Case.
3.
Install the Water Bottle Holder to the Case using the two 16 mm Fasteners, two Sealing Washers, and two Nyloc Nuts as shown in
Figure 21. Torque the fasteners to 6.0 N-m (4.4 ft-lbf).
4.
Secure your water bottle to the holder using the two Velcro Straps.
NOTE: Be sure to periodically check the tightness of all fasteners.
Removal
1.
Make sure the PT is powered off and unplugged.
2.
Remove two 16 mm Fasteners that hold the Water Bottle Holder to the Case.
3.
To maintain water-tightness, reinstall the two 16 mm Fasteners to the Case with the two Sealing Washers and Nyloc Nuts.
NOTE
Refer to the Weight Limits and Maximum Allowable Cargo Weight sections (p. 3) before using this accessory.
Velcro Straps
Fasteners
Water Bottle Holder
Figure 21. Install Universal Water Bottle Mount
Parts
(1) Water Bottle Holder
(2) Velcro strap
(2) 16 mm fastener
(2) Nyloc nut
(2) Sealing washer
Drill here
15
IMPORTANT
Be sure to read and understand all
warnings (p. 3) at the beginning of
this Installation Manual.
Nyloc Nuts
Sealing Washers

Publicité

loading

Ce manuel est également adapté pour:

X2 se side cargo frame