Segway i2 SE Lower Cargo Frame Manuel D'installation page 11

Handlebar Accessory Mount Base
24048-00001
Tools required
• 4 mm hex wrench
• Torque wrench
Installation
1. Make sure the PT is powered off and unplugged.
2. Remove the three standard fasteners from the handlebar.
3. Install the two Mount Balls and fasteners (not shown) to the Mount Base.
Torque the fasteners to 6.0 N-m (4.4 ft-lbf).
4. Install the Mount Base to the Handlebar using three 35 mm fasteners and
three spacers as shown in Figure 16. Torque the fasteners to 11.0 N-m
(8.1 ft-lbf).
NOTE
Be sure to periodically check the tightness of all fasteners.
Removal
1. Make sure the PT is powered off and unplugged.
2. Remove the Mount Base from the handlebar in the reverse order of the
above procedure.
NOTE
Refer to the Weight Limits and Maximum Allowable Cargo Weight
sections (p. 3) before using this accessory.
Parts
(2) Mount Ball w/fastener
(1) Mount Base
(3) 35 mm hex fastener
(3) Spacer
11
IMPORTANT
Be sure to read and understand all
warnings (p. 3) at the beginning of
this Installation Manual.
Mount Ball
Figure 16. Install Handlebar Accessory Mount Base
Mount Base