Segway i2 SE Lower Cargo Frame Manuel D'installation page 14

Clipboard Case with Articulating Mount
24050-00001
Tools required
• 4 mm hex wrench
• Torque wrench
Installation
1. Make sure the PT is powered off and unplugged.
2. Install the Base Plate to the back of the Clipboard as shown in Figure 19,
using three 16 mm fasteners and three Nyloc nuts. Torque the fasteners
to 6.0 N-m (4.4 ft-lbf).
3. Install the extension arm onto the Base Plate mounting ball, then mount
the Clipboard and extension arm to one of the mounting balls on the
Handlebar Accessory Mount Base.
4. Orient the Clipboard to your preference, then tighten the extension arm
securely.
NOTE
Be sure to periodically check the tightness of all fasteners and the
extensions.
Removal
1. Loosen the extension arm, then remove the Clipboard and extension arm
from the Handlebar Accessory Mount Base.
NOTE
Refer to the Weight Limits and Maximum Allowable Cargo Weight
sections (p. 3) before using this accessory.
Do not read from clipboard while riding. This will interfere with your
ability to monitor your surroundings while riding, which can lead to an
increased risk of serious injury, death, or damage to property from
falls or collisions.
Parts
(1) Clipboard
(1) 5.25-inch extension arm
(1) Base Plate with 1-inch ball
(3) 16 mm hex fastener
(3) Nyloc nut
14
IMPORTANT
Be sure to read and understand all
warnings (p. 3) at the beginning of
this Installation Manual.
Base Plate
Figure 19. Install Base Plate to Clipboard
Mounting Ball
Figure 20. Install Clipboard
Fasteners/Nuts (3 each)
Tighten here