Publicité
Les langues disponibles
Les langues disponibles
• On a product with scale, make sure that the scale is turned off before installing a protective top.
• Make sure that the protective top is secure and functions before returning the product to service.
T T o o o o l l s s R R e e q q u u i i r r e e d d : :
•
9/16 in. wrench
N N o o t t e e - - This procedure requires two people to complete
1. Press the lock pin located on the top section of each post (A) and insert the post into the slot of the plastic structure (B)
(Figure 17). Repeat for the other posts.
N N o o t t e e - - Make sure that the post is secure by checking that the lock pin is in the slot on the outside of the plastic structure.
2. Install the four posts in the accessory bracket sockets (C) (Figure 17).
3. Using a 9/16 in. wrench, lock the posts in the accessory bracket sockets with the four hitch pins (D) (Figure 17).
P P o o s s i i t t i i o o n n i i n n g g t t h h e e p p r r o o t t e e c c t t i i v v e e t t o o p p w w i i t t h h s s u u p p p p o o r r t t s s
W W A A R R N N I I N N G G
• Always make sure that both lower rails are in the locked position before leaving a patient unattended.
• Always make sure that you use the center of the lower rail to close the protective top.
C C A A U U T T I I O O N N - - Do not use the protective top as a push/pull device. Product damage may occur.
1900-009-005 REV A.2
POSITIONING FRAME
F
LOWER RAIL
E
RELEASE KNOBS
C
ACESSORY BRACKETS
F F i i g g u u r r e e 1 1 7 7 – – P P r r o o t t e e c c t t i i v v e e t t o o p p w w i i t t h h s s u u p p p p o o r r t t s s
G
B
A
P
S
LASTIC
TRUCTURE
POST
D
PINS
29
EN
Publicité
