Satelite Navigation; Easy Setup; Screen Settings - Snooper SYRIUS PRO S7000 Guide De L'utilisateur

1.Starting Up
Once you have synchronised the Micro-SD Card and
performed a download as necessary it is time to perform
the first Start Up. First make sure your vehicle is parked in
as open a space as possible, clear of tall trees and buildings
so that the built in GPS antenna has a clear view of the sky
above. Next switch ON the unit by pressing and holding the
standby power switch on the top left hand side of the unit for
2 seconds.
The following warning will be displayed.
Please read the warning and select the relevant vehicle type (where applicable).
Press "I Agree" to continue.
Whilst S7000 software is loading a start-up display will be shown for just a few seconds and then the screen will show a section of
a map. S7000 needs to acquire a minimum of four satellites in order to work. Once this has been achieved S7000 will ascertain your
position and this will be indicated by a green arrow icon on the on-screen map and the GPS signal strength will be shown in the
bottom right hand corner of the display. S7000 is now ready to navigate.
As the GPS engine and antenna have never been used before, the first 'Cold' start can take anywhere from 15 – 30 minutes to
establish a satellite connection. Once initialised, subsequent start ups will take less time and eventually should take only a matter
of minutes.
2. Easy Set Up
2.1 Screen settings
There are a number of map views or different types of information that can be displayed on the screen at any one time:-
3D
Screen views
Return to contents
Satellite Navigation
1
3
2 4
2D
6
7
5
15 • UK
North
11
10
9
8