Moser 1556 Mode D'emploi page 14

ENGLISH
Product description
de
Description of parts (Fig. 1)
en
A Blade set
B Cleaning lever
C On/off switch
fr
D Mains cable
E Battery charger
it
F Charging indicator
G Attachment comb
es
H Cleaning brush
I
Oil for blade set
pt
Technical data
nl
Hand-held appliance
Drive:
da
Battery:
Battery operating time:
sv
Dimensions (LxWxH):
Weight:
no
Emission sound
pressure level:
Vibration:
fi
Battery charger
tr
Dimensions (LxWxH):
Weight:
pl
Power consumption:
Operating voltage:
cs
The appliance is safety insulated and radio screened. It meets
sk
the requirements of EU Electromagnetic Compatibility Directive
2014/30/EC and Machinery Directive 2006/42/EC.
hr
Operation
hu
Preparation
sl
Keep the packaging material for safe storage or
transport later.
ro
f Check that the contents are complete.
bg
f Check all the parts for possible transport damage.
Safety
ru
Handle with care! Damage due to incorrect power
uk
supply.
f Only operate the battery charger with the voltage
et stated on the nameplate.
Charging the battery
lv
Before the appliance is used for the first time, it
lt should be charged for approx. 16 hours!
1. Connect to the mains power supply (Fig. 2)
el
2. Switch off the appliance using the on/off switch (Fig. 3ⓑ).
ar
14
DC motor
Ni-MH battery
up to 120 minutes
151 x 37 x 30 mm
approx. 150 g
max. 63 dB(A) @ 25 cm
< 2.5 m/s
2
90 x 106 x 62 mm
290 g
max. 2 W
220 – 230 V AC / 50/60 Hz
3. Place the appliance in the charging stand. The charging
process starts.
· Ensure that the appliance is switched off. Switch
position 0 must be visible (Fig. 3ⓑ), otherwise the
battery will not charge.
· During charging, the charging indicator (F) on the
charger is illuminated.
· Recommendation: the battery should only be
recharged when the performance of the appliance
has deteriorated considerably. However, charging
the battery for longer than the specified length of
time will not cause any damage.
· After the appliance has been removed from the
charger, the display goes out.
It should take approx. 12 hours for the appliance
·
to charge to full capacity.
Battery operation
1. Switch on the appliance using the on/off switch and switch
off after use (Fig. 3ⓐ/ⓑ).
· The appliance may be operated for up to 2 hours
with the battery fully charged. This capacity is
attained after approx. 5 - 10 charging cycles.
· In case of insufficient maintenance of the
blade set, the operating time can be reduced
considerably.
Operation
Cutting with the attachment comb
The appliance can also be operated with an attachment comb.
f The attachment comb has 5 detent positions for adjusting
the cutting length.
f The further the attachment comb is pushed onto the blade
set, the shorter the cutting length.
The cutting length can be adjusted from 3 mm
(Fig. 5ⓐ) to 6 mm (Fig. 5ⓑ).
Attaching/removing the attachment comb
1. Slide the attachment comb onto the blade set (Fig. 4ⓐ) in
the direction of the arrow until it locks in place.
2. The attachment comb can be removed by pushing it in the
direction of the arrow (Fig. 4ⓑ).