Publicité
Les langues disponibles
Les langues disponibles
7.4.5 REPLACING THE INVERTER (ONLY ESTUCS900)
To replace the inverter proceed as follows:
1.
Disconnect the electrical terminals from the corresponding slots on the Inverter (Fig. 32);
2.
Remove the screws that fix the inverter to the supporting bracket;
3.
Take the new inverter and set the DIP switch as the inverter to change (Fig. 33);
4.
Fix the new inverter to the supporting bracket and connect the electrical terminals to
their seats (Encl. 7). For power and signal connection 0-10Vdc, refer to the wiring dia-
gram attached to the machine.
Fig. 32-ESTUCS900
8. GENERAL CONDITIONS OF WARRANTY
Mechanical and electrical parts are guaranteed for 24 months beginning from the date the
unit is delivered ex-works in Pordenone. The warranty only covers factory defects and not
malfunctions caused by improper installation or wrong connection.
9. LIST OF RECOMMENDED SPARE PARTS
Upon specific request by the customer, EURAPO will supply a list of available spare parts and
will suggest their choice taking the following factors into account:
•
number of units installed;
•
type of unit;
•
number of hours of operation per year;
•
ambient conditions in the installation area.
Fig. 33
EN
1
2
3
4
5
6
7
8
9
10
+
53
Publicité
