Publicité
Les langues disponibles
Les langues disponibles
9
10 11
12
13
9
Sew slowly and stop the machine when a buttonhole is
completed.
*
The machine sews the front bartack and left row first,
then the back bartack and right row.
10
Cut both needle and bobbin threads leaving about 10 cm
(4") thread ends.
Draw the needle thread to wrong side of fabric by pulling
the bobbin thread.
Then, knot the threads.
11
Insert a pin inside the bartack.
Then cut the opening with seam ripper.
Take care not to cut the stitches.
12
To repeat buttonhole sewing, turn the stitch selector to
, then back to
Now, simply step on the foot control to sew an identical
buttonhole.
13
When buttonhole sewing is finished, push the buttonhole
lever upward as far as it will go.
To adjust buttonhole stitch density :
Stitch density of buttonhole sewing should be adjusted within the
mark "
" on the stitch length dial.
21
again, as shown.
Publicité
